Innovita Primo 6 LPG Gas Water Heater | 6 L/min

Innovita Primo 6 LPG water heater

The Innovita Primo 6 LPG gas water heater is a compact instantaneous water heating solution designed for static caravans, holiday homes, park homes and off-grid properties.

Using LPG fuel and battery-powered electronic ignition, the Primo 6 produces hot water on demand without requiring a conventional storage cylinder. The appliance can deliver up to 6 litres per minute at a 25°C temperature rise and has a maximum output of 11.6 kW.

Its compact wall-mounted design makes the Innovita Primo 6 particularly suitable for installations where space is limited.

Key Features

• Innovita Primo 6 LPG gas water heater
• Up to 6 L/min at ΔT25°C
• 11.6 kW maximum output
• LPG operation at 37 mbar
• ErP A+ energy rating
• Instantaneous hot-water production
• Battery-powered electronic ignition
• No permanent mains electrical supply required
• Flame failure device
• Low-NOx combustion
• Maximum water temperature of 60°C
• Operating water pressure from 0.2 to 10 bar
• 90 mm flue diameter
• 1/2-inch BSP gas and water connections
• Compact wall-mounted construction
• Suitable for static caravans and off-grid applications

The published Primo 6 specification confirms these key operating characteristics, including 6 L/min flow, 11.6 kW maximum output, 37 mbar LPG pressure, A+ efficiency and battery ignition.

Instantaneous LPG Hot Water

The Primo 6 is an instantaneous LPG water heater, meaning it heats water as it is required instead of storing a large quantity in a tank.

When a hot-water outlet is opened, the appliance operates to provide hot water.

This makes the system suitable for smaller properties and mobile or semi-mobile applications where a compact hot-water solution is preferred.

The maximum published flow is 6 L/min at a 25°C temperature rise. Actual flow depends on incoming water temperature, desired outlet temperature, water pressure and other installation conditions.

11.6 kW LPG Water Heater

The Innovita Primo 6 has a maximum heat/output rating of approximately 11.6 kW under the specified operating conditions.

Its compact output makes it particularly appropriate for lower-demand hot-water installations, including individual sinks, showers and small accommodation facilities.

For applications requiring substantially higher hot-water flow, the larger Innovita Primo 11 should be considered instead.

6 L/min Water Flow

The Primo 6 provides up to:

6 litres per minute at a 25°C temperature rise

This figure is important when selecting the appliance because actual water flow changes according to the temperature difference between incoming cold water and the required hot-water temperature.

Therefore, the 6 L/min figure should not be interpreted as a fixed flow rate under every operating condition.

Ideal for Static Caravans

The Innovita Primo 6 LPG water heater is particularly suited to compact accommodation and caravan applications.

Potential applications include:

• Static caravans
• Holiday homes
• Park homes
• Holiday lodges
• Cabins
• Small off-grid properties
• Compact accommodation
• LPG-powered secondary hot-water systems

Its wall-mounted design helps conserve installation space.

Off-Grid LPG Water Heating

The Primo 6 uses battery-powered electronic ignition, so it does not require a permanent mains electrical connection for ignition.

This makes it useful for off-grid installations where electricity availability may be limited.

The published specification identifies battery power as the ignition supply.

ErP A+ Energy Rating

The Innovita Primo 6 carries an ErP A+ rating.

The published specification also lists approximately 89% efficiency at maximum power.

The actual energy consumption of the appliance will depend on hot-water demand, operating temperature, incoming water temperature, LPG supply and usage patterns.

Low-NOx LPG Water Heater

The Primo 6 uses a combustion system designed to limit nitrogen oxide emissions.

Published specifications list maximum NOx emissions of approximately 29 mg/kWh.

Installation and emissions compliance should always be assessed according to the appliance documentation and regulations applicable in the country of installation.

Compact Wall-Mounted Design

The Innovita Primo 6 has published dimensions of approximately:

550 × 255 × 246 mm

and an empty weight of approximately 8.5 kg.

Its compact footprint makes it suitable for installations where available wall space is limited.

Before installation, allow the required service and safety clearances specified by the manufacturer.

Morco Replacement Water Heater

The Innovita Primo 6 is commonly marketed as a replacement for several older Morco LPG water heaters, including:

• Morco EUP6
• Morco MP6
• Morco D61B
• Morco D61E

This makes the Primo 6 a relevant search target for customers looking for a Morco replacement water heater.

However, replacement suitability should always be confirmed before installation. Existing pipework, flue arrangements, ventilation, gas pressure, clearances and current regulations must be checked by a suitably qualified installer.

LPG Gas Supply

The Primo 6 is designed for LPG operation with a published gas supply pressure of 37 mbar.

The appliance must be connected to the correct LPG supply and installed according to the manufacturer’s instructions and applicable national gas regulations.

90 mm Flue

The Innovita Primo 6 uses a 90 mm flue according to the published specification.

Because the Primo 6 is a gas-fired appliance, correct flue installation and ventilation are essential.

The installer must confirm the flue route, terminal location, ventilation requirements, clearances and appliance configuration before commissioning.

Safety Features

The Primo 6 incorporates a flame failure device, designed to shut off the gas supply if the burner flame is lost.

The appliance also includes battery-powered electronic ignition, allowing ignition without a permanent mains electrical supply.

All installation, commissioning and servicing should be completed by an appropriately qualified gas/LPG professional.

Technical Specifications

These specifications are based on the published Primo 6 product information.

Innovita Primo 6 vs Primo 11

The Primo 6 and Primo 11 are both compact LPG instantaneous water heaters, but the Primo 11 is the higher-flow model.

Primo 6

• Up to 6 L/min at ΔT25°C
• 11.6 kW maximum output
• Compact lower-demand solution
• Suitable for smaller hot-water requirements

Primo 11

• Up to 12 L/min at ΔT25°C
• Higher output
• Better suited to larger hot-water requirements

Choose the Primo 6 when the calculated hot-water requirement fits its 6 L/min capacity.

Is the Innovita Primo 6 Suitable for a Caravan?

Yes. The Primo 6 is specifically marketed for static caravans and off-grid installations.

Its compact dimensions, LPG operation and battery-powered ignition make it well suited to caravan and holiday-home applications.

Does the Primo 6 Need Mains Electricity?

No permanent mains connection is required for ignition.

The appliance uses battery-powered electronic ignition.

What Is the Primo 6 Flow Rate?

The published maximum is 6 L/min at a 25°C temperature rise.

Actual flow varies according to water temperature, required outlet temperature, pressure and operating conditions.

What LPG Pressure Does the Primo 6 Use?

The published LPG supply pressure is 37 mbar.

What Size Flue Does the Primo 6 Use?

The published specification identifies a 90 mm flue diameter.

Can the Primo 6 Replace a Morco Water Heater?

The Primo 6 is commonly marketed as a replacement for Morco EUP6, MP6, D61B and D61E models.

However, compatibility must be checked before installation because the existing flue, ventilation, gas supply, connections and installation environment may require assessment.

Is Professional Installation Required?

Yes.

The Primo 6 is an LPG gas-fired appliance. Installation, commissioning and servicing should be performed by a suitably qualified professional.

The installation must comply with the manufacturer’s instructions and the applicable gas, ventilation, flue and safety regulations in the country of installation.

Buy Innovita Primo 6 LPG Gas Water Heater in Europe

The Innovita Primo 6 LPG Gas Water Heater is a compact solution for customers who need instantaneous hot water in static caravans, holiday homes, park homes and off-grid properties.

With 6 L/min flow at ΔT25°C, 11.6 kW maximum output, A+ ErP efficiency, battery ignition and a 90 mm flue, the Primo 6 is designed for compact LPG hot-water installations.

Select the appliance according to the required hot-water flow and installation conditions, and have the system installed and commissioned by a qualified LPG/gas professional.